pattersonlee's latest activity

Dart 302 block pushed to a 347 Edelbrock water pump Aviaid oil pan with custom baffles. I am running MSD 6ALN ignition and distributor...

Rob - nice stuff. What are the specs on the block, water pump, oil pan, distributor ? thanks Lee

Canton shows the following gasket set for their pan: 4 piece job. I would ask them...

Keith, I wish you all the best on your health. Only know you through this forum, but I followed you build from years ago. Peace brother.

At this point, what is left attached to prevent you from just pulling the motor and trans together and allowing you to do this right. I...

In case you haven't seen this one, ready to drive away...

Unless your barrels were "sealed" at the top, the two barrels would eventually level off (assuming they are both the same diameter)...

The triangles connect circuits between the 13 pages of electrical diagrams. Note page reference next to letter.

Curious what the red Triangles are on the wiring diagrams? each one has a letter in the middle of it but I see no reference to them...

Randy - regarding your build sequence, I don't think you can install the fuel tanks/cells with the front suspension installed. I know...

I know members that have used these guys to make replacement fuel cells for replicas. Would be curious to know their position is (as...

The prevailing setup on the Pantera which is very similar in overall shape and size (low to the ground, little front air intake area...

Thanks Bill - good to hear and yes, so very sad for the people. We will always respect the island. Cheers.

We are going in a month. Bill, what services were limited? We stay north of Lahaina. thanks.

Douglas - your part looks darn good to me. Question, could the STEP file be used to have someone machine this part from thin aluminum...