GT40s.com - View Single Post - Introducing New CNC Billet Aluminum Uprights

Fred W B · 07-31-07, 04:22 AM

I though the previous detail looked a bit skimpy where the steering tie rod end attached to the upright. It's much beefer now, but you have now moved the tie rod end inboard a lot. As above, this would cause big changes in the steering geo if you want to retofit to existing cars?

I thought pitman arms were only found on street rods?

Regards

Fred W B

07-31-07, 04:22 AM	#9 (permalink)
Fred W B Fred W B 2 Tenths Join Date: Jul 2006 Location: Port Elizabeth Posts: 245 Rep Power: 5	Re: Introducing New CNC Billet Aluminum Uprights I though the previous detail looked a bit skimpy where the steering tie rod end attached to the upright. It's much beefer now, but you have now moved the tie rod end inboard a lot. As above, this would cause big changes in the steering geo if you want to retofit to existing cars? I thought pitman arms were only found on street rods? Regards Fred W B