GT40s.com - View Single Post

Mark Worthington · 2nd January 2009, 11:57 AM

Thanks guys for your helpful suggestions and photos. I'll rummage through my box of RF-supplied mouldings tonight, and if the door seal stuff doesn't work, I'll place yet another order with McMaster Carr. I knew I had seen what I wanted there before, but searching for rubber moulding, rubber trim, and weatherstripping didn't show me the products I was looking for. I think one of these two would be best suited for this application:

or

For future reference, these products are shown on pages 3368-3371 of the McMaster-Carr catalog.

2nd January 2009, 11:57 AM	#8 (permalink)
Mark Worthington Mark Worthington 10 tenths Join Date: Dec 2001 Location: Massachusetts GT40: RF No. 36 Posts: 1,925	Re: Rubber moulding for rear clip to spyder Thanks guys for your helpful suggestions and photos. I'll rummage through my box of RF-supplied mouldings tonight, and if the door seal stuff doesn't work, I'll place yet another order with McMaster Carr. I knew I had seen what I wanted there before, but searching for rubber moulding, rubber trim, and weatherstripping didn't show me the products I was looking for. I think one of these two would be best suited for this application: or For future reference, these products are shown on pages 3368-3371 of the McMaster-Carr catalog. __________________ Regards, Mark RF Chassis No. 36 still under construction 347, MoTeC EFI, pin drives, leather, etc.