Rear axles

Rune

Supporter
I am about to order cv930 for my car , and wonder where to order, and have not idea witch axles that is good enough to handle 450+ hp. Someone with a solution here?
Rune
 
Rune,

It sounds like you are asking about driveshafts/CV joint shafts, not axles, right?

The axles are inside the hub carriers, ride on axle bearings, the wheels bolt to them etc?
 

Rune

Supporter
Yes it is the shaft between the two cv joints I am asking about , the most I have seen is for dune buggies and I belive they snap if used in a 450 hp car . And where to order them because I will need a correct length.
Rune
 

Terry Oxandale

Skinny Man
Sway-away axles (used on my near 500HP motor), EMPI, as well as any number of generic 930 CV splined axles have worked fine on my vehicles. Never had a failure or twist on any of these two mentioned economic axles. Never felt I had to go with the 300M either. They come in various lengths to fit just about any application.
 
Back
Top