Greetings fellow owners and wannabes,
My name is Mark and my first post will be to forward all of you some info I put together on an engine management system.
I'm building a 351 for my ERA that has been stroked out to 427. I have found the Hilborn EFI unit (8 stacks) to be most appealing and the Electromotive control system to offer the most. Yes I want closed loop O2 and knock sensing.
Here's the pricing and other info for the Electromotive TEC III system.
ECU 1850
harness 160
4 coil direct ignition 280
sensors
MAP 70
water temp 27
manifold temp 27
O2 75
knock 65
EEPROM firmware upgrades
outputs
8 - dedicated injectors
4 - general purpose (fan switch, A/'C cutoff at WOT)
1 - 4 wire idle speed control
4 - A/D (Wheel spin sensor?) I could hack some traction control into this if they weren't about to release a unit for T/C
All this and the technical dude said I can stop buy the factory, buy it there and milk them for any technical information I might need. And they're only 30 minutes away!
Anyone else in the Northern Virginia area building anything fun?
Mark
My name is Mark and my first post will be to forward all of you some info I put together on an engine management system.
I'm building a 351 for my ERA that has been stroked out to 427. I have found the Hilborn EFI unit (8 stacks) to be most appealing and the Electromotive control system to offer the most. Yes I want closed loop O2 and knock sensing.
Here's the pricing and other info for the Electromotive TEC III system.
ECU 1850
harness 160
4 coil direct ignition 280
sensors
MAP 70
water temp 27
manifold temp 27
O2 75
knock 65
EEPROM firmware upgrades
outputs
8 - dedicated injectors
4 - general purpose (fan switch, A/'C cutoff at WOT)
1 - 4 wire idle speed control
4 - A/D (Wheel spin sensor?) I could hack some traction control into this if they weren't about to release a unit for T/C
All this and the technical dude said I can stop buy the factory, buy it there and milk them for any technical information I might need. And they're only 30 minutes away!
Anyone else in the Northern Virginia area building anything fun?
Mark