Front bonet pivot hinges

[Bob Stoeger]

Hi All,
First off Ron if this is in the wrong forum, sorry,
I need ideas on how to change the way that my GTD front bonet pivots the original hinge is poor at best, so I thought I should ask what else others have done, and take advantage of the wealth of info that is on the web sight. Any info or pics, of what anyone else has done will be helpful.
Thanks,
Bob

 

[Frank Catt]

Bob, I make lift off hinges ( similar to those on the back of the original cars ) that allow the front clip to rotate 90 degrees to vertical then just lift off, Frank

 

[Andy Green]

Hi Frank,
How does you solution compare to the Tornado design. Do you still have a cross-bar on the front & rear clams? Any photos would be appreciated

Regards
Andy

 

[Bob Stoeger]

Andy,
Thanks for asking the same question that I was going to ask Frank.
Do you have any pics to see.
Thanks,
Bob