Hi all,
Fitting the dashboard at present. The moulding is a copy of the KVA I believe, and I have modified each end to allow removal without disturbing the screen/spider/roll cage.
However, once roughly assembled, the front edge of the dash hangs in space, just under and just short of the spider. The gap between spider and the top of the dash varies a bit, from about 25mm to 40mm or so at the edges.
Does anyone have any suggestions for sealing this gap, and to stop the dash top vibrating?
Clive
Fitting the dashboard at present. The moulding is a copy of the KVA I believe, and I have modified each end to allow removal without disturbing the screen/spider/roll cage.
However, once roughly assembled, the front edge of the dash hangs in space, just under and just short of the spider. The gap between spider and the top of the dash varies a bit, from about 25mm to 40mm or so at the edges.
Does anyone have any suggestions for sealing this gap, and to stop the dash top vibrating?
Clive