Hi All
Just thinking about how I'm going to route all my pipe work from the front to the back of the car and just wondered how you all did this. I was hoping to be able to run it all through the centre console but there isn't the space.
At the moment my centre console has the 2 main cooling pipes (38mm OD)in it wrapped in that high exhaust wrap. I'm also going to run my brake lines low underneath them. The air on hoses to the back are the large Dash 10 & Dash 8 pipes and these will just fit (Thick wall rubber pipes) but they will be touching the wrapped cooling pipes. Can I get smaller OD pipes for this to leave a bit of a gap or use metal pipe but I'm not sure how to connect these. Ive still got to run a servo hose through there and I'm now thinking of running the heater hoses through a bulkhead fixing then down the outside of the passenger side panel.
Thanks in advance
Jase
Just thinking about how I'm going to route all my pipe work from the front to the back of the car and just wondered how you all did this. I was hoping to be able to run it all through the centre console but there isn't the space.
At the moment my centre console has the 2 main cooling pipes (38mm OD)in it wrapped in that high exhaust wrap. I'm also going to run my brake lines low underneath them. The air on hoses to the back are the large Dash 10 & Dash 8 pipes and these will just fit (Thick wall rubber pipes) but they will be touching the wrapped cooling pipes. Can I get smaller OD pipes for this to leave a bit of a gap or use metal pipe but I'm not sure how to connect these. Ive still got to run a servo hose through there and I'm now thinking of running the heater hoses through a bulkhead fixing then down the outside of the passenger side panel.
Thanks in advance
Jase