I have a Topend IDA quad set up on my engine. They assured me the thread size for the temp gauge sender was 3/8 NPT.
This size was to small so I got a 1/2 NPT adapter, this appears to be the right size but only does up a few threads. However, that seems to be the case on this video https://www.youtube.com/watch?v=e3FvTLG4uqY
Can anyone confirm if 1/2 NPT is the correct thread size, picture of hosing below.
This size was to small so I got a 1/2 NPT adapter, this appears to be the right size but only does up a few threads. However, that seems to be the case on this video https://www.youtube.com/watch?v=e3FvTLG4uqY
Can anyone confirm if 1/2 NPT is the correct thread size, picture of hosing below.