I have a 944 transaxle that I want to marry to a Ford Duratec 3.0L engine. What I am looking for is:
1. accurate bolt hole/locating pin dimension data for the tranny and engine. Alignment of the adapter plate is crucial.
2. any tips on installing a hydraulic throwout in this trans?
3. I have a Ford pressure plate/clutch assembly from an MX75 tranny which bolts to my crank and slides onto the spline. This is not a question, just pure glee at finding this combo!
1. accurate bolt hole/locating pin dimension data for the tranny and engine. Alignment of the adapter plate is crucial.
2. any tips on installing a hydraulic throwout in this trans?
3. I have a Ford pressure plate/clutch assembly from an MX75 tranny which bolts to my crank and slides onto the spline. This is not a question, just pure glee at finding this combo!
