Clutch pipe size?

[Jon]

Out of interest, what size clutch pipe have people installed?

I am using a un1 transaxle and full size mustang clutch, so am thinking that 3/16ths might be a bit small.

[Jack]

Actually Jon, 3/16ths (AN-3) should be fine.

[Ian Anderson]

I run 3/16 and on fast full power changes the glitch slips for a bit before grabbing.

If I was doing it again I would run 1/4 or have the slave sleeved down so as not to move so much fluid to disengage the clutch fully

Normal road use no problems at all

Ian

[Malcolm]

GTDs used to come with small clutch lines but the general form is now to use a 1/4 inch pipe.

[Jon]

Thanks guys. I think I'm leaning towards 1/4 inch.

[Mike Pass]

I use 1/4"
Cheers
Mike

[Jac Mac]

Its relative to Master Cyl bore size & fluid flow, bigger bore shifts more fluid so therefore requires bigger dia, better to play it safe & use 1/4". More likely to cause problems on clutches with diaphragm during power/high rpm shifts where the diaphragm is held flat or over/center due to centrifugal force.