Renato
Lifetime Supporter
Hi all,
Looking for input on which way to go with half shafts. Any experience or advice would be greatly appreciated.
Option 1 - bottom setup in the picture:
Using standard half shaft "off the shelf" with aluminum (or steel?) adapters to O1E.
Option 2 - top portion of the picture:
Using outer joint from the shaft (pictured) and inner joint from Audi. Custom shaft with Audi splines on one end and Ford splines on other end.
Possibly a third option?
Renato
Looking for input on which way to go with half shafts. Any experience or advice would be greatly appreciated.
Option 1 - bottom setup in the picture:
Using standard half shaft "off the shelf" with aluminum (or steel?) adapters to O1E.
Option 2 - top portion of the picture:
Using outer joint from the shaft (pictured) and inner joint from Audi. Custom shaft with Audi splines on one end and Ford splines on other end.
Possibly a third option?
Renato