Flywheel fitting ZFQ bellhousing

Hi,

the flywheel on my Roush engine was too big to fit in the ZFQ Bellhousing.

The bellhousing is 361 mm inner-diameter.

Anyone can advise on a suitable flywheel?

thanks!
 
Hi Jonas I think there is some confusion over flywheels if you use the Zfq bell housing you will want a 157 teeth flywheel from a v8 our flywheel is smaller it is fitted to sgt cars using original size Zf bell housing you can use our flywheel but would require a different starter motor adaptor which I can probably make .
Regards mick.
 
Back
Top