I have a 016 in my KVA, just lost 1st gear and after disassembling found that the rear bearing on the pinion output shaft punched through the back of the case?... I caught this immediatly and it doesnt appear that there is any other damage to the internals.
Question is, can/should I attempt to have the back face machined down and add a steel sandwich plate, which would need to include the bearing race support, or do i scrap this tranny and find another?
And any suggestions where to find another 016 or is it easy to change to a 01e, or any better options now?
Thanks for your input.
Robin
Question is, can/should I attempt to have the back face machined down and add a steel sandwich plate, which would need to include the bearing race support, or do i scrap this tranny and find another?
And any suggestions where to find another 016 or is it easy to change to a 01e, or any better options now?
Thanks for your input.
Robin