Rear Wheel Tub

Michael Fling

Supporter
I have searched several build logs, but I am not sure of the position/direction of the corrugated pieces that go in front of the rear wheels. A few questions I was hoping someone could help me with (pictures would be appreciated if possible)...

1. One side has a widen 90 degree flange. Does that wider flange mount against the body or go to the inside?

2. There are corners cut out on on end. Does that mount to the top or bottom?

3. Is the corrugated area opened or vented for heat escape or for pressure. Has anyone ever left it solid? BTW- I have side exhaust.
 
Here's a couple pictures. I trimmed mine back near the lower control arm bracket for clearance,, slotted the horizontal ridges, used rubber washer against panel to frame and used modified small "L" brackets to existing nuts/bolts on body work. These are older pictures - if you need more just say so -- Mike
 

Attachments

  • IMG_3562.JPG
    IMG_3562.JPG
    276.1 KB · Views: 500
  • IMG_3563.JPG
    IMG_3563.JPG
    294.4 KB · Views: 481
  • IMG_3566.JPG
    IMG_3566.JPG
    303.7 KB · Views: 486
Did the reset of the inner liners (front and back) go in as expected? I have read there is a pattern that needs to be followed/cut out.
 
Back
Top