Front Clip Modification.

Peter Olliviere · 08-26-06, 01:46 PM

At some point a running change was made to the front clip of the RF in which partial bulkheads were added to each side of the clip. It seem that the purpose was to close off the open passage between the door hinge area and the wheel well and to stop the sides of the clip from curling in when open.

I would like to add these bulkheads and am looking for a picture for guidance to see how the factury did it before I design my own.

Thanks Peter

Jim c · 08-26-06, 08:02 PM

This forum page 2
body fit questions by Jim c
Bill posted pics as I have same problem

Jim
www.mentalperformance.com.au

Bill Hara · 08-27-06, 10:17 PM

Here is the url

body fit questions

Peter Olliviere · 08-28-06, 06:17 AM

Thanks to all who replied, I now have the pattern and pictures I needed to add the bulkhead. The only problem I have with getting it installed is twerling down around Cuba.

Well here we go again, time to stop checking the forum and start putting the shutters on the house. I have grown to hate hurricanes.

Peter