welcome to GT40s.com! If you've never posted on the forum maybe give it a go by introducing yourself in the Introduce Yourself Here forum. Also, think about becoming a Forum Supporter at GT40s.com. Becoming a supporter will allow you more PM space, an avatar, and the money is used to keep GT40s.com running.
Enjoy the forum!
Welcome to the GT40s.com, the World’s Largest GT40 resource.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, view pictures, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, Join Our Community Today!
Why not start with your first post today and become an active part of GT40s.com now! And, if you find you enjoy GT40s.com think about becoming a Forum Supporter.
Location: 59 years old. Went to college in Florida during the Ford-Ferrari wars. Was a pit steward for the D
GT40: WV
Posts: 183
Rep Power: 7
Information Query ... clip mnt thread diameter
Guys,
It is my understanding that the RF GT40 uses a "T" shaped adustable mount on each side for the rear clip. It has threaded rod section horizontally and vertically to provide the adjustment of clip location.
Can someone please tell me the approximate diameter of these threaded rods. I am going to make a similar mount for a different chassis and want to make sure I get it beefy enough.
Thanks very much!
__________________ Mike Starling
Sabre 6210
351W 4bolt SVO block
Luntati crank, Oliver rods
T&D tubes and rockers, internal balance
506 fwhp@6500 rpm, 481 ft-lb@4200 rpm
Information Query ... clip mnt thread diameter 
Linear Mode
