Need an adapter plate for ZF

L

Linder

• Nov 10, 2003

• #1

does anyone now where to buy the adaptor plate between my ford 302 and my zf 5speed 7 bolt tranny.
best regards
michael linder /ubbthreads/images/graemlins/confused.gif

"Post moved by Ron, it needs to be placed in the proper location not in the builder's forum. The builder's forum is for builders to show their progress"

 

H

Hershal Byrd

• Nov 10, 2003

• #2

Here ya' go Linder, these folks have what you need.
http://www.kennedyeng.com/

Hersh /ubbthreads/images/graemlins/smile.gif

 

L

Linder

• Nov 11, 2003

• #3

Thanks Hershal
for helping
best regards
Michael linder /ubbthreads/images/graemlins/grin.gif

 

Fran Hall RCR

GT40s Sponsor

• Nov 11, 2003

• #4

Try Roy Snook in England too,I think he had some custom cast.
[email protected]

 

M

Mark Worthington

• Nov 11, 2003

• #5

Didn't Ross Nicol get a ZF-to-SBF bellhousing from Bob Putnam at ERA? I would think that would be the best solution, although it may also be the most expensive in terms of both time and money.

 

J

• Nov 11, 2003

• #6

ERA has these adspter plates. They also have the cast hanger that goes on in place of the inspection cover. Big block adapter plates are available from Kennedy Eng. in Cal. I don't believe they cast a 302/351 yet.

 

R

Roy Snook

• Nov 11, 2003

• #7

I believe ERA have 302-7 bolt Zf bellhousing available

 

L

Linder

• Nov 12, 2003

• #8

hello
I have email kennedy eng. and waiting for reply regarding my plate.THen i can either contact era or try to make one off my own.I have never tryid it before but one time has to be the first.... /ubbthreads/images/graemlins/wink.gif /ubbthreads/images/graemlins/wink.gif /ubbthreads/images/graemlins/wink.gif
best regards and thanks for helping
michael linder