Hi
I have had my RF40 for over 6mths.
It sits in my workshop & I look at it everyday.
This week end I finaly got a start.
I pretty much got through all the internal sheet work.
While doing this I used sealers ect ,but it becomes clear that if care was not taken you could end up with more water on the inside than the out.(in bad weather)
As a lot of you have built kit cars and if you were to do it again are there some extra precautions that you would take that might help me.
This comment is is not pointed at the RF its a general veiw
I would like to make that clear.
Jim.
I have had my RF40 for over 6mths.
It sits in my workshop & I look at it everyday.
This week end I finaly got a start.
I pretty much got through all the internal sheet work.
While doing this I used sealers ect ,but it becomes clear that if care was not taken you could end up with more water on the inside than the out.(in bad weather)
As a lot of you have built kit cars and if you were to do it again are there some extra precautions that you would take that might help me.
This comment is is not pointed at the RF its a general veiw
I would like to make that clear.
Jim.
