Guys
My questions are
1) How much material is typically milled off from the front of the bell housing to shorten it?
2) What exactly is the purpose of this?
3) Is there any down side to doing this?
4) what's the up side to doing this?
I thought I ask the group before calling a trans shop.
Thanks for any help you can give on this subject.
My questions are
1) How much material is typically milled off from the front of the bell housing to shorten it?
2) What exactly is the purpose of this?
3) Is there any down side to doing this?
4) what's the up side to doing this?
I thought I ask the group before calling a trans shop.
Thanks for any help you can give on this subject.