I put my GTD-40 on a dyno @ Superformance today. The 351W put 413 hp on the ground @ 6000 rpm
GT-40 on Dyno - YouTube
GT-40 on Dyno - YouTube
GT-40 on dyno
- Thread starter Sam McDowell
- Start date
Sounds sweeet. Keep the rubber side down!
Robert S.
GT40s Supporter
Sam, great looking ride, good numbers! Help me out here, was that dyno at Superformance in Irvine Ca., or at some other location? Your info indicates you are in Statesville, NC.
Thanks, Robert
Robert, The dyno is in North Carolina, near Salisbury.
Superformance/ Olthof Racing.
You should see this place. There where 5 GT-40s (plus mine), 3 Daytona coupes and 6+ Cobras there in various stages of maintenance.
They have a just completed EXACT recreation of a 427 Mark IV. Sounds mean!!!
I guy in Denver NC built 6 new GT-40s by original plans.
Superformance/ Olthof Racing.
You should see this place. There where 5 GT-40s (plus mine), 3 Daytona coupes and 6+ Cobras there in various stages of maintenance.
They have a just completed EXACT recreation of a 427 Mark IV. Sounds mean!!!
I guy in Denver NC built 6 new GT-40s by original plans.
Attachments
Last edited:
Tom,
Good eye!
It was running rich in the mid range. They made a change to the jets and that cleared it up. It also added 15 hp.
Last pull was 413 hp @ 6000 and 436 ft/lbs @ 4200
Sam
Good eye!
It was running rich in the mid range. They made a change to the jets and that cleared it up. It also added 15 hp.
Last pull was 413 hp @ 6000 and 436 ft/lbs @ 4200
Sam
Similar threads
