Where to get valuable design information?

I am very interested to know where I might get actual data that I can use to design GT-40's on CAD. I would love to print copies full size and hang them up on the wall. Does anyone out there know where I can find such information? The info must exist somewhere due to the fact that replicas are being manufactured. Any clues would be helpful.

Jeff, are you looking for chassis or body info?

Full size?? I suppose if you had access to a plotter that was 48" wide and used roll paper you could fit a side view.

There are a couple of guys that are working on a GT40 in Auto CAD. One of them is Jim Dunham.

Here's the topic on it. http://www.gt40s.com/cgi-bin/ultimatebb.cgi?ubb=get_topic&f=1&t=000505

Has any one found out any more?

Doug

[ July 07, 2002: Message edited by: Doug Barry ]