I apologize if this has been covered before but I couldn't find it:
I was double checking on a flat surface today my wheel camber. I used a digital level and came up with the following readings in degrees:
left front: –1 degree ////// right front: –1.4 degree
left rear: –1.2 degree ///// right rear: –1.3 degree
1) The manual gives specs in MM’s & I’m not sure how to convert MM to degrees.
2) Does anybody have the specs in degrees.
3) And, has anybody noted the amount of degree change if I rotate the upper control outer ball joint (see pic) one turn.
Or am I close enough for government work.
I was double checking on a flat surface today my wheel camber. I used a digital level and came up with the following readings in degrees:
left front: –1 degree ////// right front: –1.4 degree
left rear: –1.2 degree ///// right rear: –1.3 degree
1) The manual gives specs in MM’s & I’m not sure how to convert MM to degrees.
2) Does anybody have the specs in degrees.
3) And, has anybody noted the amount of degree change if I rotate the upper control outer ball joint (see pic) one turn.
Or am I close enough for government work.