There are two wires (brown, and gray/black) protruding from the black wiring harness on the rear body deck. The wires are wrapped nicely (tie-wrapped) above the opening where the twin exhaust pipes protude through the body.
My question is, what are they for?
If by chance either, or both can be used to provide current for a lighted license plate frame, please tell me how to do it.
If they are not related to providing power to a lighted license plate frame, could some one tell me how I can provide power to a billet aluminum lighted license plate frame I just purchased.
And, if it makes more sense to respond in the relatively new "HOW TO" section of the forum, provide the instructions there.
Thanks.
My question is, what are they for?
If by chance either, or both can be used to provide current for a lighted license plate frame, please tell me how to do it.
If they are not related to providing power to a lighted license plate frame, could some one tell me how I can provide power to a billet aluminum lighted license plate frame I just purchased.
And, if it makes more sense to respond in the relatively new "HOW TO" section of the forum, provide the instructions there.
Thanks.