Replicas of Gurney-Westlake Valve Covers

Status
Not open for further replies.
Can someone post a picture of a GW valve cover? I did a search of both the forum and the Internet and came up empty.

Thanks
Bill D
 

JimmyMac

Lifetime Supporter
Bill,
Here is mine.
 

Attachments

  • 58085-EX289ENGINE.jpg
    58085-EX289ENGINE.jpg
    32.6 KB · Views: 9,620
Hi Guys

If the demand is great I can get some more cast, the charge is £200 per set and I know the exchange rate with the $ has been bad recently it seems to be easing a little.

Regards

Chris Melia.
 
Chris-

I sent you an email re: this subject. But now that you have responded on the forum, I'M IN!!! Will they look like the ones pictured above?

Thanks
Bill D
 

JimmyMac

Lifetime Supporter
I also have rollers/girdles and machined quite a bit out from the insides. I also linished and milled the externals.
Chris supplies these covers in the original sand cast finish for painting, as were the prototypes.
As sold, in my opinion they are of excellent quality for the money.
Nice job Chris.
 
I am also interested in a set or two !
look great !
my exhaust is already tight, but it looks like it would work .
 
Status
Not open for further replies.
Back
Top