Can anyone suggest where i could find a suspension utilizing unequal length a-arms and rod end bearings, for a mid engine car weighing around 2000 pounds with 500 horsepower/G50 trans? I know this is a broad subject and a very general question but i've poked around quite a bit and havent been able to find exactly what im looking for. I've been planning on using corvette c5 suspension, ala factory five gtm, but im having a few interference problems in the foot box because of the shear size of the cast aluminum a arms, and im not too keen on using rubber bushings or having to convert it to coil over shocks and springs. So basically im looking for something similiar that is more compact in its a-arm design that would utilize simliar geometry and rod end spherical bearings. Was thinking about using c5 uprights and fabricating a arms myself but id like to avoid having to weld a arms. Was looking at viper suspension components as they are more compact in their a arm design and already use coil overs shocks/springs but they still use rubber bushings. Not building this thing for comfort! Thanks for reading this and any ideas would be greatly appreciated!