Does any one have a wiring diagram or have experience
Wiring up 83/84 rx7 mirrors tried using the search
But had no luck
Many thanks in advanced
for any advice or help
over due update
car vent off for its iva in june 2014 and passed
made a few changes to exterior and interior
swapped the lower round lights for square ones
got rid of the centre console that covered the gear shift and wiring loom
added an engine cover
and relocated the primary fuel...
more pics
fitted a fog and reverse light got wiring completed
got the dash and roof flocked put the carpets in
build a center console over the center tunnel
hi all
bit of an update got some more pics to upload
these are pics of my custom gear knob with lift up reverse
i also repositioned the bracket for the cross gate cable so it doesnt
stick out the bottom of the rear clip any more and got some heat shielding on
time for a little update after the summer holls just getting back in to it
got the body roughly fitted all heating and cooling pipes done
ecu mounted not sure if the location is best down near the ac compresor but the only space i could find
also made a plate to mount the battery
Time for an update
James - sometimes i think i have bit too much fun and lose track of time done a few unintentional late nights lol
David - going for the 5l coyote and un1 box
got quite a few things done brakes and clutch lines are all done
engine and gear box in fuel system done had...
a few more did some extra paneling to cover the fuel filler pipes
got it on its wheels for the first time albeit only for a couple hrs while
i had a clean up and made a start on the brakes
Hi Everyone my name is Abraham
took delivery of my tornado mk1 carbon mono
on 11 of may 2013 thought it was time to start a build log
i will get some pics asap
thanks