Recent content by gnx7

So now that summer is dwindling down..... what has the car run at Sears Point, Laguna Seca, Thunderhill so a West Coast racer can see its performance potential?

Are you planning on double O-ringing the block/heads.... or do you think that the 6 bolt head pattern will suffice to hold the heads in place at 1500hp? Who is building the motor? Should be one bad mofo when it is done. You should also look at the new Holley Dominator EFI system. Has...

This motor Randy is pretty much one of the best bang for the bucks out there. While the LS3 bore is larger you would still spend more money to make the same power. Dave aka RX-Heven can vouch for my character. <input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();"...

I can't believe that nobody has scooped this up. Of note: The shortblock was completely torn down to install new cam bearings (I nicked one when I pulled out the stock cam) and I also installed new rod bearings at the same time. The main bearings looked fine and the rest of the motor was...

to the top <input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden">

I sold the wiring harness from this setup. Price drop $5K firm. I will crate up at no cost; however shipping is on your dime. [email protected] Thank you, Mark <input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden">

I went 196.2mph at the Texas Mile :) That car moves for sure. Naturally aspirated setup. To the top!

to the top Leaving for TX Mile this Fri-Sun..... trying to hit 190mph n/a in a 440ci LS7 shortblock/TrickFlow235cc/FAST 90 engine/T56 in a friend's '93 RX-7. It went 10.5@140mph n/a on Nitto NT-01 275/35/18's in road race trim. He installed a more aggressive cam and gained 40rwhp with no...

replied to emails

I have a used '99 Fbody LS1 (all alum) shortblock 5.7 liter with approx 60K miles on it. It is complete with everything and stock unless mods are listed. The shortblock is stock aside from Katech rod bolts (perfectly weighted and used in SCCA Vette racing) which allows it to be spun to 7,000rpm...

After Dave had it unloaded into my shop I was tempted to put my LS7 inside of it to spite his 20B intentions..... J/K :thumbsup: It looks awesome in white. I was impressed by the suspension A-Arms and other CnC'd pieces. Should be a killer vehicle when it is completed. After hearing the 4...