jlwdvm's latest activity

I wish, but probably not in the cards for me. Hopefully there are a few owners that document the whole thing with lots of reference photos.

If my car was done, I would load it up and head that way....but that wont be for a couple of years!

Anyone from Iowa on here? I'm located on Iowa's east coast (Quad Cities) and have been chipping away at a Active Performance project for...

I have a FI Prestige 363 in my 66 fastback. It was dynoed at the shop prior to shipment. After I got it installed, we ran into a few...

I had heard that the new owners were going to tweak the chassis a little. This is my 3rd car project, with my previous builds being...

I bought mine 18 months ago from Chris (the original owner). He had mine done in 6 months.

I am finding there are lots of things with the AP body that need to be re engineered!

Refitting the rockers…the underside of the lip will need to be worked down a little since it is now fatter than shipped due to the extra...

Rear curves in about 3/8”…front appears straight.

Correct, at least this side curves in at the rear tire end (I'll have to check the front tire end). I noticed this when I was trying to...

Final trim isn’t done yet, but much better than before….since it will be visible when the rear clam is lifted.

I’m pleased with how this turned out. Once it gets trimmed down evenly, it will cover the frame rail underneath.

Fortified epoxy and a layer of 1708. I’ll be able to trim down to 2 1/16” when I pull it off the mold.

What are your panel gaps set at? Those look great!

It looks like a 3rd grader trimmed and installed my rockers prior to shipping. The top edge was terribly uneven, too narrow, and warped...