Recent content by Vee

umm your right Rich. I sat in my cars and inside most of em. (Not all) the steering wheel is a little off center from the seat and I noticed my leg rest against the center console in the smaller ones with just a little wiggle room also..

Omg! Thanks! Just what I wanted to see! ive been looking at a lot of pics to find out if others have put them there !The slc wiki says the race tail has LESS room for the mufflers than the street tail. So when I was shopping for mufflers i was a little worried about room and cables... BUT when I...

Thanks joel!! I just wanted to make sure before I start seting my pipes up.

These are pics... IF I would have mounted my muffler on TOP like I see on most slc' ..theres not much room on the passenger side ..A 5 or 6 inch ROUND muffler will be really tight and closer to shifter cables...the 4" round muffler goes through the support braces on top passenger side with no...

Is it OK to put my mufflers through diffuser? (>Magnaflow mufflers 4" diameter -case is 14" total length 20").... it seems to be the best fit...Just asking before I start tack welding my exhaust...thanks!! (I might be able to fit round 5 or 6" mufflers and other sizes too if i put them in this...

Joel. this is what Ive used for years on my car builds..the MD is a clay consistency stays like that forever seals great and ez to work with and can fill big gaps. get it at lowes/Hme depot...The 3m strip caulk is very sticky, (I don't use it where someone will rub against it because it...

For the factory brake line set up ...see allens videos on youtube.. Lots of info on slc.

ill get the heat shields and brackets from you ...

The dash gauge ..it has the rpm, tack ,gas gauge etc.

No not at all. Just showing what it looks like. It works and looks nice. I have the screen taped while I'm working to keep it nice.

The wiki shows the round gauge which is no longer being sent.