Search results

I have a carbon fiber hood that I want to inlay gt40 type twin vents. Where can I buy the vents only here in the US Thanks Mike

I am using a UN1-13 in a project which we just got on road. Using a Toyota cable shifter, we are having a terrible time with the shifting gates getting out of alignment and the shifting locking up. I've had the rear case off three times now. Any suggestions on how to improve on this? I...

I need a driveshaft about 18" long with 28 spline(for 930cv) on one end and 33spline(for 100mm cv) on the other end. Is such a shaft available off the shelf or does it have to be custom made? I know it doesn't make sense but I am very cramped for room on the outboard end and will be putting...

I am using a UN1-13 in a build and want to use 100mm cv's rather than the usual 108mm 930 cv's because I don't have room for the 108mm cv's on the outboard end. My info is that the Ford Granada flange from GT racing and the Delorean flange both go to the 108mm 930 cv. Is there a flange...

As I mate a UN1 to an engine and bellhousing, the input shaft is 2"s too short. Several machinist suggested making a new shaft which is expensive and one said that if I went to a properly equipped axle shop, they could weld a different clutch spline end on and heat treat it. This could make it...

As I flip the crown gear on my UN1-13 for a rear engine application, I realize I loose the mechanical speedo output. Has anyone figured out an electonic speedo output that might fit in the same hole? Thanks Mike

I am going through a UN1 box I found. Maybe we could swap for the 3.44 gears that are in it. Rebuilder says they are good. Mike 253-301-1624