gauge

Hi all Have a little issue with my CAV and its oil pressure gauge, When the ignition is turned on, the needle travels the extent of the gauge from 0 to 100 Is the fault with the gauge or the sender? Also, where is the sensor? Thanks Will

Hi guys my right hand fuel gauge has stopped working on my 1991 GTD any ideas what to look for first and where to look might be a bad earth not sure Cheers Paul

Re-installed the exhaust system after having an O2 bung welded onto the driver side collector and having the entire system freshly ceramic coated. Installed an AEM AFR gauge on the lower left face of the instrument panel just above the left hand sill. Fired up the motor to test the gauge...

I looked for wideband AFR gauges, which seemed a little overpriced for what I thought was essentially a 0-5V gauge. (I already have a Bosch WB sensor and controller feeding 0-5v to an Emerald K6 ecu). So, I tried my multimeter, but impedance is too low and drags down the signal to the ecu. Any...

The original builder/owners of this car took an interesting, but less preferable approach for the twin tank fuel system. Each tank has a dedicated pump, filter, regulator and gauge feeding one bank of cylinders. This means both pumps need to operate full time. See attached system diagram...

I finally got around to test fitting the dash, Koso gauge and steering wheel. With the seat in the most rearward position and flat on the floor and the steering wheel positioned comfortably, I can’t see the Koso gauge through the top half of the steering wheel. Lowering the steering wheel...