intake

Anybody knows where the engine compartment thermoswitch is mounted - the one that the brown/black wire goes to? Is in the intake manifold or in the block, thanks -Steve

Selling my LS3 valley cover modified for reverse installation. I built a LS9 engine instead. The oil sensor tower was cut off and the surface milled to accept the included LS3 Katech adapter. This adapter is the more expensive one designed for the LS3 intake manifold. It doesn't require any...

Jared's GT-R, build by H Craft Customs. GM LT4 power Graziano transaxle. Options coming, Trunk, Power steering, Carbon fog lights, Tail lights, Hinged trunk and Engine cover, Tuck roll hoop into A pillars, Wheel arches, Rear bumper, and Carbon Head light buckets. First task is to...

Guys, I was keeping this for the Mangusta, but that has moved on to a new owner. Don't worry, have not gone over to the dark side yet, bought a Pantera just to keep the punishment up!! So far car is doing just that....nicknamed her "Erica" (Days of Our Lives....Susan Luci...!) Owned it 5...

I want to put four 44 idf webers on my 293 build. I have noticed that there are two different styles of intake for quad webers. One has a single coolant outlet that looks like it would house a thermostat and the other has two outlets. Im not sure what is the right intake for a gt40.

Hi all, I'm new and Factory Five forums suggested I come to this site. Long story short My father used to own a dealership in the bay area in 1994 and I have a whole lot of parts. But the one that has me up at night is the Crower 8 pack intake manifold. I cannot figure out what it goes on...

I fitted the intake manifold, but was suspicious of the fit as the lower part of the gasket looked a bit loose, sure enough I can get a feeler gauge in there. Not just in one place, but each cylinder. The top part of the gasket is sealed but not the bottom as though the angle is different. As I...

I know I saw a picture of a Coyote engine with the intake turned 180 degrees but I can't seem to find it. Can some one point me in the right direction? Anyone with experience doing this please chime in. Problems or issues I should know about? Thanks, Hugh