Adam C.
GT40s Sponsor
Original pattern headers made from Jigs made by Kenny Thompson.
This is the very last set of 5 that I made around 2005.
Super light .035" thick 2.25" diameter 321 Stainless steel.
Correct angle merge collectors, correct mounting tabs, flanges, doublers etc. Expanded and lap welded per original. Correct slip-rolled and welded tailpipes.
Attached are pictures of them test fit in chassis 1032 before we started restoration.
The diameter/bend combination is very difficult to get, and these are very labor intensive. I doubt I will ever make more. Get em while you can!
$5500
This is the very last set of 5 that I made around 2005.
Super light .035" thick 2.25" diameter 321 Stainless steel.
Correct angle merge collectors, correct mounting tabs, flanges, doublers etc. Expanded and lap welded per original. Correct slip-rolled and welded tailpipes.
Attached are pictures of them test fit in chassis 1032 before we started restoration.
The diameter/bend combination is very difficult to get, and these are very labor intensive. I doubt I will ever make more. Get em while you can!
$5500