Recent content by Bob from Cleveland

  1. B

    Any slc for sale?

    Still looking for a car ?
  2. B

    Rumbles SLC Build

    THANKS !!
  3. B

    Rumbles SLC Build

    Can I ask who did the bodywork and paint on your SLC ?
  4. B

    Difference between a heat exchanger and Oil cooler

    Controversial is right !! I made many calls. Custom fuel cell company said it's fine ... Just don't leave it in over the winter. They suggested run one tank of regular fuel through the car before storing for extended time. I did change all the fittings, lines, pumps, regulators, and injectors...
  5. B

    Difference between a heat exchanger and Oil cooler

    The shop that does my tuning and machine work has a few 1000HP+ CTSV customers. All using a single pump. (LSA has only one in and out) .. On my car I have an aftermarket pump that draws from the 1gal tank. -12AN line feeds the blower. Then a -10AN "Y" tee sends hot coolant to left and right...
  6. B

    Difference between a heat exchanger and Oil cooler

    I wasn't sure if the engine itself would have heat issues, so I was worried about putting one up front. I also thought about the "chillers" but overall cost was the issue for me.
  7. B

    Difference between a heat exchanger and Oil cooler

    The LSA "brick" that draws the heat from the intake charge is small (heater core size) I am using 3X the surface area to reject the heat across the two exchangers. I am also using a 1 gallon tank for a thermal "cushion" FYI.
  8. B

    Difference between a heat exchanger and Oil cooler

    To all guys with intercoolers !! One issue I had was air trapped in the coolers. Water temps were wacky ... After trying MANY ways to bleed it out ... I ended up installing small bleed valves on top of each cooler.
  9. B

    LSA SLC Build Log

    Yes ... Connector is a four pin Delphi (Only need outside two to operate).
  10. B

    LSA SLC Build Log

    https://www.e-motioninc.com/ACTUATOR_CONTROLS_s/6.htm I used an MC200 .... One on each side for safety.
  11. B

    LSA SLC Build Log

    The Tesla parts are cheap, and available. Replacement pads are even on RockAuto. I'm saving up for paint so cost was a bonus too!
  12. B

    LSA SLC Build Log

    IT'S GOKART TIME ! Hope you guys can open the file !!
  13. B

    LSA SLC Build Log

    I will have the Tesla calipers powder coated to match later ! :)
  14. B

    LSA SLC Build Log

    This is a universal controller that will run them. Fully adjustable force settings. Calipers were $65 Ebay. Controllers $90.
  15. B

    LSA SLC Build Log

    Fits like it was made for it !
Top