Hi I am on the look out for a set of driveshafts for a type c KVA.
These have ford CV's at either end but need to be approx. 415mm long .
Cant seem t find any that short from standard ford fitment. Has anybody any experience on this issue they can share? Or have they had some made from...
Was always a bit sceptical of these miracle aluminium solder type products, But bought some at the Classic car show yesterday and have to say I am pleasantly surprised.
I have just tried a joint that will only be used for cosmetic purposes but I think with a bit of polishing and cleaning will...
Well done to all those who put on a good display at the NEC. Was good to catch up with a few of you and I am now a member of the club. Well on paper anyway, full steam ahead for the build completion!!
Well think this is possibly my 4th version , Think I will stick with this, rough fit at the moment and panels to clean up but think it will be ok. can remove the front panel to access the filler hose and this is also sealed from the interior so hopefully ok for the IVA
Yip I have to second the car park parking fee avoidance technique.
Usually works , I don't do it intentionally but after the live action arena demonstration of the autosport show finishes there are no parking booths open!!
So the moral is don't pay when you go in wait until you leave!!
I am going to try and go down to this. We usually do the Autosport show in January but getting a bit the same after 10 years going.
Hope to meet up with a few of the club members. But I suppose I better join first!!
See you guys there!
Both your cars are progressing well.
Don't think there can be any cars that are the same as everyone goes about things completely different.
First attempt. Panelling needs tidying up and cleaned/polished but trying to enclose the full area.
Guys. I am struggling a bit with the panelling on the front of my KVA around the fuel filler caps and into the front of the windscreen area. I have been putting it off for ages but really need to get it done now. Has anybody got any pictures from around that area? needs to be watertight but...
Thanks Murray. Its getting there. Engine up and running. sounds superb. Taken a lot longer than expected but had a couple of prolonged holdup with other commitments and a change of job but started on it a couple of months ago and need to finish for March as have to build a horsebox for the start...
I have just installed the megajolt. Which is basically the same but for the ignition only. I have made the loom and toothed pickup etc , been installing over the last couple of months and eventually got round to firing it up for the first time yesterday. Initially I got the firing order wrong...