Recent content by magmills

  1. M

    Mirage M1 - Original Clutch Set Up

    305 engines used in 1967. Monza(M10001,M10002), Spa(M10001), Le Mans(M10001, M10003) Ref: R.Spain GT40 Hope this assists regards mike
  2. M

    Mirage M1 - Original Clutch Set Up

    James the best i can offer is to point you to Ronnie Spains book. Pages 306 and 307. Mirages rebuilt as 1074 and 1075. Suggest you check your photo information on these 2 chassis No's. Also Page 142 lists the gearbox numbers used between 1967-69. Hope this helps. mike
  3. M

    try jay cushman regs mike mills

    try jay cushman regs mike mills
  4. M

    Martin John Shands monococque is for sale in N.Z. if you are interested Cheers Mike Mills...

    Martin John Shands monococque is for sale in N.Z. if you are interested Cheers Mike Mills (Franks mate)
  5. M

    Go Kart anyone?

    I'm no engineer but the thrust line and engine location look too far above and behind rear wheels? Any other thoughts? regards mm
  6. M

    Ford France paint codes please.

    Sorry can't help with codes, but have photo's from previous restoration which may help you with the stripe spacing. Hope these are of use. mike
  7. M

    Front Suspension Upper and Lower Control Arm Bearings

    Thanks for your assistance. 'every little helps' regards Mike
  8. M

    GT40 Engine Build Mirage Chassis

    Re: My coffee table....... Most impressive Doc, ingenius lightweight coasters. the silver stirrers have helixes to stir more efficiently and the other end for better grip. the mesh keeps insects out of the cups during polite conversation and you have even provided a shaker for the...
  9. M

    Original Specification Parts

    Jim the silence may be deafening to you, because we stand in awe. Please keep posting as you are showing us the hidden gt40. best regards mike
  10. M

    Diesel GT40 ?

    un-modified citroen ax 1500 over 70mpg and a neck breaking 0-60 in 4.5............mins mike
  11. M

    Mirage gt40

    pdf a3 drawings of different views. regards
  12. M

    Galvanizing process

    Hi jake, hot dipped galvanising is a high temperature process in which the steel has to be raised to the molten temperature of the galvanising bath in order to achieve proper zinc adhesion. during this process the welds and parent metal of the fabrication tend to be stress relieved and...
  13. M

    Mirage gt40

    hi rene welcome to the forum. you can use the links in the previous replies to go to web pages with the mirage photos. best of luck with your project mike
  14. M

    Alfa Romeo gt40 enemies..

    Hi apul, I owned a 1968 alfa romeo 1600 gulia sprint gt veloce. rust was a big problem and from memory the 1600 could have the crankshafts ground but the 2000 couldn't. the 1600 gtv also had a more robust mainshaft and many of the main drive components were not interchangable between models...
  15. M

    It has to be said....

    Hi stuart I too have had little gain from raising my question regarding the mirage on the forum, even though RE posted my request on the main entrance. 1100+ views 12 replies. i did however contact a couple of the guys on the forum by private message, one being frank catt, who is local to me...
Back
Top