Thanks for reply Clayton
Oh yeah I see it now yes that would swing.
Is yours a race car where you have mounted with four points? Mine is a road car. I am a bit concerned that it will try and twist the weakest part, perhaps the adaptor plate, if the mounts are different stiffness between...
Hi Everybody
Just wanted some advice on mounting the transaxle. I spoke with the engineer and he said to only use three points of mounting, two for engine and one for gearbox. I am using an audi 012 gearbox and it has two mounts on it. What have you guys done for this? I assume you use both...
Hi Everybody
I hope Iam posting in the correct section. I have an Audi 012 gearbox which is being used as my transaxle and hoping to use the audi half shafts as well. I am using a Corvette's C5 rear suspension and uprights. I need to adapt the half shafts to fit into the corvette upright or hub...
Hi Everybody
I am building a mid engine car at the moment but am having trouble with mating the gearbox an Audi 012 to the engine an Alfa 3litre V6. The alfa flywheel is too big fit inside the bellhousing. I need to use this for the starter to work. Also because the Alfa V6 is externally...
Hi Russell
Thamks dso much for your reply. So do you have a gearbox that is the same ie CXY or did you asdk about it at Audi for me? Otherwise are they pretty cool if I ask them myself? Do you think they would have any drawings of the box? I Know this one definately came out of a 4 door A4 V6...
Hi evrybody
I have read a lot of stuff on this forum and it seems there are a lot of experts on here in regards to transaxles. Unfortunatley I dont own a GT40, yet! but washoping someone might be able to help me out with my question.
I bought an Audi gearbox from an A4 V6. I believe it is a...