Recent content by Mike Coates

Speedo Cable. I obtained my Smiths to Audi 016 from United Speedometer Service 2431 University Ave, Riverside California. Check out there web at www.speedometershop.com Contact Carl at 909-684-0292. Fax 909-684-0146 You will need a ratio adaptor. Their web site will provide information on...

Hi Ron. The message below was received in my inbox. Has any other member received such a message? It was from [email protected] and the subject is This Site Hacked By Saudi Hackrz:) Please advise. Regards Mike C Hi This Site Hacked By Saudi Hackrz :) Don't Worry ...

Hi Paul. What was used to connect the cables to the Transaxle. It looks like a good set up. Mike

did not geet your address yet. Please forward. Mike

Hi Dave. I will make a copy of the drawings and sketches for you. please send your email address so that we can communicate off the forum.I will need your postal address. Mike

Many thanks Dave. What engine are you using with your Audi transaxle? I mounted my transaxle to a 302 Ford. I made my own adaptor plate and aluminum flywheel. I have the drawings if they would be of any help to you. Mike

Does anyone know the the ratio of the clutch release leaver on the Audi 016 transaxle. My transaxle is installed so I cant measure it.

Hi Don. I do not know where you are located, however this should help you resolve your problems. You need a ratio adaptor to correct your speedometer. The adaptor can be fitted on the back of the speedometer gage or on the transaxle where the cable enters. United Speedometer Service in Roverside...

You have raised some interesting points Bob. I have given this a lot of thought and can’t decide which would be the safest location. The end of the vent needs to be at least as high as the filler cap otherwise if the tank is filled to the top of the filler neck (perhaps not intentionally), gas...

Mark. Do you know which car had the same color as 1049 but had the orange moustache rather than the regular orange stripe as per 1049. On the back cover of John S Allen's book it has a number 9 on the front.

Hi Chris You are correct, that is exactly how they work.

Hi Ian. Yes that is what I am looking for. I think I will see if I can find one in a wrecking yard as David suggested. The RS Components switches look like they would work, but size could be a limitation as I am using it in a remote mount Tilton reservoir which is quite small. Will try the...

Hi Simon. Do you know the paint code colors for the dark blue and orange as in your picture? I want to paint my car this color

I had good service from Pegasus alos. Good people to work with and very fast service. Would recommend to others.

Hi Jim. Have not found anything yet. Will advise when I do.