Recent content by Primoglass

Chris, I will send you a few clips of my prints since there are a few variations between cars as they were being built. that way I will be sure to get a good fit. I will have to reboot to free up memory

nice set of posts on gearing I intend to adapt a tiptronic transmission to a poly phase electric 400V AC water cooled traction motor producing 240 NM of torque from 2000 RPM to 8000 RPM with a top end of 11000 RPM should be interesting in a 13500 lb car. SO should be abel to reprogram the...

chris would you be willing to sell a body kit and uprights for the suspension. I have a 906 0riginal drawing for body and space frame I am looking to purchase a body and the mag suspension uprights. Russell

I am creating a scratch built 906 of sorts. Starting with a scanned scale blueprint vector files are being created for each piece of tubing. I am looking to recreate as accurately as possible the space frame as the starting point. Does any one have any dimensions for tubing diameter and...

chris I recent purchased a 906 blueprint. I am going to have it scanned into a tif and gif file format. my intent is to render a 3d space fame that will allow a load frame stress analysis. I plan to replace the fuel tanks with LiPo Batteries charging from a 3 phase 400V AC induction motor after...

looking for a 906 body, I recently purchased a full sized blueprint and am planning tp construct the space frame to create an EV adaptation. do you have a source? russell

Hi there. I will be starting on a 906 Porsche project starting with a frame build. I am wondering if you would be willing to sell a complete body kit. I plan to install a 200 hp 3 phase AC. Motor. I am using a digitized blueprint set to configure battery, and ultracapicator batteries for weight...