Hi,
Pic #1 is as-delivered from SPF. Notice the hi location of the e-brake cables.
Pic #2 shows the cables turning sharply to miss the front drive then going aft.
Good luck,
Steve
HVAC Fan Run-on with Key-off
Fuses 15 & 16 are always hot and supply relays J & K respectively.
If relay J fails closed, the HVAC fans will run at medium speed with key-off.
If relay K fails closed, the HVAC fans will run at high speed with key-off.
Hi,
With the ignition key off:
If relay A or B sticks closed, both fans run at low speed
If relay C sticks closed, one fan runs at high speed
If relay D sticks closed, neither fan runs
Relays A & B are interchangeable
Relays C & D are interchangeable
Any of the HVAC switches and sensors can...
Hi,
That Brn/Bk wire is intended to give an FI ECU control over the fans. Grounding this wire produces the same action as engaging the fan override switch on the dash. The water temp sensor is up front on the drivers side of the radiator.
Good luck,
Steve
Hi,
The LS-style bleed system is more than a way to help fill the system without an air pocket. Engines produce vapor when are run hard and need a place for this vapor to condense. The header tank serves this purpose. Having the phase change at hot spots is an efficient way of locally cooling...
Hi,
Photo 1 shows the demister ducts tie wrapped as from the factory after the dash is off. The duct on the bottom goes to the right side eyeball vent.
[/url]Defrosting Ducts by Steven White, on Flickr[/IMG]
As the hoses come out of the heater unit:
The forward top hose goes to the left...
Hi,
The wiper park relay is powered thru fuse 11 and is hot if the wipers are parked with the key-on. SPF choose to use a common 3 position switch rather than a wiper specific switch then they added a relay to enable a park function. This relay is behind the small dash access hatch to the left...
Hi,
Here are some pics of the Olthoff shifter on a ZF and my ZF mocked up out of the car.
Steve
OlthoffShifter by Steven White, on Flickr
OlthoffShifter2 by Steven White, on Flickr
ShifterMockup by Steven White, on Flickr
Hi,
I have been helping Blas with the wiring diagram by using my car as a standard from the factory. We have run into an issue with the front lights wiring. My car, P2319, has the right & left lights reversed compared to the factory info. Three factory documents are consistent in that they show...
Thanks for your memories!
Lynn, your posts have been the best info for a self-installer. I am just starting 2319 and your photos and recommendations have been a great help.
Thanks for the efforts,
Steve
Thanks for the generous offer Ron.
I will PM you to exchange contact info.
I bought a ZF-2 from a '72 Pantera about 40 years ago and have been lugging it around from house to house. I was building kit cars with some friends at the time and I thought I might use it in a Manta, than a V8...