Recent content by Stewart Rough

Thanks Jack, my email is [email protected]

Hi Jack I'm interested in the wheels, but I'm in Australia. Could you ship them to Perth? Also could you post some pictures?

Hi do you still have this trans available? If so will the Kennedy Engineering plate suit it? I have the KE adapter plate clutch and starter motor for the au 5.0 litre v8. I purchased another trans in pieces and can't get it put back together and need another to fit up to what i have. Regards...

Thanks Bill & Chris for organising this event. I was my first ride in a GT40 and it gave me a big boost to know that building one, i will eventually be able to drive a great car. It was also great to meet everyone that went to the day and share stories of various additional requirements...

I have looked at a couple of factories in Bayswater that are about 140m2 which is bigger than I require. Is there anyone interested in sharing a factory for build/storage purposes? The factories have a large roller door and one also has a roller door over the small office section and all seem...

Does anyone know of a small workshop in the eastern suburbs of Melbourne that is available to hire or lease. I have no room at my place and could also use some storage space. Regards Stewart

re: RF #12 "Race" Chassis Looking good Troy. I've managed to add the front suspension to mine. I have lots of bits to assemble to the front end and still have engine - trans to assemble as well. With the new baby arriving last week I think time may be a rare commodity in the next few weeks...

I recently brought an AU falcon 302 from a wreckers and was wondering if any other aussies have used this engine in there GT40. My main question is how to mount the accessory drive at the front of the engine. The alternator and AC compressor that came with the car has mount that are 90 degrees...

The US is a great place where something like 30,000 are killed each year with guns. A lot of those are probably accidents involving family members and you are the School shooting capital of the world. I watched Michael Moores film Bowling for Columbine and think how lucky we are in Australia...

Can somebody let me know how to create the radius on the top gear change panel at the rear that matches the side of the gear change panel? I don't have access to a roller though.