Fran,
It was my introduction thread, not the start of my build thread. I was looking for a member and can't think of his name. They didn't reply In my build introduction. Maybe I can call you and you might be able point me in the right direction tomorrow.
cannon plug
I remember seeing the post your are speaking of. It used a cannon plug at the Blum head. I thought it was in Ken's or McFlings. I looked briefly and did not see it.
Anyways I had considered something like this
I'll look for the actual post later
I should been more specific the ones I was speaking of are aft of the side windows. Appear to be taped in 1/4 masking tape.
I can't believe you changed it again lol. Wait yes I can…I love some of what you did. I would love to fly out there take some measurements and put my spin on it. I suck...
Rear louvers
Scott,
Have you thought about making the rear louvers out of Lexan? (Polycarbonate etc...)
Have you also thought about a high mount 3rd break light? Sounds silly I know but thought I would ask.
For heat you may look at Kool Mat then taking advantage of low and high pressure areas to draw air into the engine compartment may help. Fran might be able to provide some more information on belly pans for race applications.
I have also considered, if I were to build this car, ducting the...
LED Tails
I planned on using something similar to what Fling has. Ken Roberts found them on this side of the pond. check them out here Specifically these.
Maybe he can point you where he got his just tossing this out there :)