Bumping this thread since i am about to plan the plumbing of heater hoses/pipes.
I want to make sure the circuit actually works, but i don't want another pump to force it.
What is my best bet then?
(I run a electrical main circulation pump and no thermostat)
Should i weld in an angled connector...
All relays are bought with internal diodes to quench that spike.
I know my electronics, so no problems there, just wasn't able to find a suitable switch for the last function needed for my instrument panel.
I might have a problem on hand here, i asked smith how to drive their GT40 spec tacho gauge, and the answer seems to be that MSD 5520 make to large of a signal voltage and it just swamps the gauge and it drops down to zero instead.
Since this seems to be a theoretical problem so far (since i...
I bought an std aircon kit from carbuilder.com.
But the wiring, is it actually as described on the homepage?
Because the industry standard seems to be that the blue wires switches the compressor on, and not the condensor fans...
I am about to start planning the wiring loom for the car excluding the engine wiring that will be a separate loom directly from the engine management system.
Any standard looms documented that i could use as a starting point and modify to get a complete picture? (Looms for gt40 replicas that is)
Thanks all for the great replies.
I have decided to implement Dynamat superlite in one layer around the cockpit, and then a thin isolatating foam mat for the tunnel, rear bulkhead, and front bulkhead.
I will probably be using the golden heatshield you linked in there Howard, seems appropriate in...