Search results

  1. J

    Hydraulic clutch tube size?

    I'm plumbing from the clutch master cylinder to the slave cylinder on my Miura project. I started down the path of using 3/16" SS tube and -3 AN fittings. I then noticed the slave cylinder has -4 AN fittings on it. I googled it and found mixed answers on use of 3/16" versus 1/4" tube for...
  2. J

    Detached Workshop Garage Design

    The Miura project continues to be in a "hold pattern" due to our move from CA to AZ. The bad news part of the move is that there is less garage space at our new home than I had prior. The good news is that we have plenty of land space and no harsh regulations preventing the construction of a...
  3. J

    Exhaust heat shields

    I have a situation where the headers run very close to key engine and transaxle components and also close to the firewall (thus the driver/passenger seating areas). I'd like to build in some heat management provisions and am hoping there are some who've "been there, done that". The...
  4. J

    Air leaks with slip fit collectors and EFI causing rich A/F?

    I am in the middle of fabricating headers for my Miura project car and was warned by someone that single slip merge collectors can leak air in causing a faulty O2 sensor reading that leads to a rich A/F condition. So my question out to others that have a similar setup (EFI and equal length...
  5. J

    Coyote cross-over header design

    I'm at the point of designing the headers for my Coyote powered Miura. The engine sits transverse but that really just means I need to build custom headers because there's no chance someone will have already built headers for this application due to zero other cars having this engine and engine...
  6. J

    Electric water pump and digital controller question

    Does anyone have experience (good, bad, so-so) with the Davies, Craig electric water pumps and digital controllers? Specifically, Davies, Craig has recommended the EWP150 pump (150 lpm/40gpm) pump along with their digital EWP/fan controller (...
  7. J

    Modern-day Miura

    This is a build diary for my home/scratch built Lamborghini Miura SV car project. I’m about 3 years into the project so there’s a fair bit done but as anyone who has undertaken this type project will say, the majority is still yet to come. The original impetus for the project was to make a...
  8. J

    New member - any interest in a scratch built Lambo Miura build thread?

    Hi, my name is Joel Heinke and I'm located in the San Francisco bay area, Livermore CA to be specific. I have to confess, I have an affliction that I suspect most of you have to; a deep seated passion to build and drive the highest performance sports cars from the 1960's era. I have built and...
Top