Search results

  1. T

    Lift kit problems

    I am using Ramlift pro lift kit front and back. Rear is ok. But on the front i am having problems achieving correct ride height. I have even fitted 3 inch springs to try and get the ride height low enough (about 4.5 inches) but can‘t get any lower than 5.3 inches ride height with it wound all...
  2. T

    Adjusting rear camber

    Guys , how are we supposed to adjust the rear camber? I understand that it is the single rose joint nearest the chassis that must be adjusted but I can’t even get a spanner in three for the backing nut. Do I need to remove it all, guesstimate an adjustment and put it all back together again...
  3. T

    Wheel single central nut / spinners - correct tightening direction

    Hi guys, apologies if this has been done to death already but I’d like to start with a clean slate as I am getting conflicting advice from various ‘experts.’ what is the correct direction of tightening for the single central wheel nuts / spinners? Is there a right and wrong way or is it a grey...
  4. T

    Roll Cage question .......

    Guys, is there a real cause for concern that the roll cages may actually inflict heavy injuries on the occupants if involved in a road accident (i.e. without wearing helmets)? I know there is a requirement for the roll cages for racing and track use but then we wear helmets. But can the roll...
  5. T

    GT40 seats

    Can anyone tell me which seats these are and where I can buy them ?
  6. T

    Quick ratio steering rack for G T Racing chassis (ex MDA kit)

    Does anyone know which quick ratio steering racks can be used with the G T Racing GT40 kit (ex MDA kit)? I would like about 2.0 turn to turn or thereabouts (without limiting the degrees of turn) but also without introducing bump steer. Any ideas? Thanks.
  7. T

    Flywheel and crank mismatched bolt holes

    Guys, Hit my first issue in my build (which at moment is limited to engine assembly as chassis and parts not due until later this year). I found that only 5 of the 6 flywheel bolt holes line up with the crank. Do I need a new flywheel or can anything be done to my current arrangement to make...
  8. T

    Flywheel and crank bolt holes mismatch

    Guys, Hit my first issue in my build (which at moment is limited to engine assembly as chassis and parts not due until later this year). Whilst doing a mock up of my engine parts I found that only 5 of the 6 flywheel bolt holes match up with the crank. Do I need a new flywheel or can...
  9. T

    Tyre options

    Hi Guys, Whilst I am waiting for my chassis and other parts to show up I am researching various aspects of the build and currently obsessing about tyres. I am defiant in my use of 15 inch wheels despite it limiting my tyre choice. Are these the only rear tyre choices available for 15 inch...
  10. T

    Flywheel weight for ZFQ transaxle

    Hi guys, Can anyone tell me what is the weight of a good quality flywheel for a ZFQ transaxle mated to a 302 stroked to 331 engine ? Would you consider 8.5kg as being too heavy?? Thanks.
  11. T

    Hi from Bishops Stortford, UK

    We live in Bishops Stortford (UK). After a few months of researching and following all you guys on here I decided to splurge on my first kit car. I placed my deposit for a GT40 rolling chassis and other parts which i hope to receive before the end of the year and commence my build in earnest...
Top