Search results

Hi, I have just fitted my gearbox and engine assembly in to the car and found that the bellhousing is touching the chassis before the tail of the gearbox is low enough to bolt to the mounting brackets. I know i will need to remove some material from the underside of the bellhousing to get the...

Hi, I'm at the stage of making a header setup for my kit. I have been in touch with a fabricator to make a plate that follows the design of a standard 302/289 exhaust gasket. The plate will then be the base to which I start attaching the header tubes. I'm going for a stainless steel setup so...

Does anyone have a recommendation for a suitable engine crane to use with the a forty? I'm based in the UK so i have been looking at clarke cranes but i'm not sure home much a fully assembled cast iron small block weighs and therefore which one i need!

Does anyone know a good source for air-con hose fittings in the UK? I am trying to find somewhere that sells male o-ring bulkhead fittings, i can find a few places in the states but nothing local. p.s. apologies in advance if this post is in the wrong place but it seemed like the closest fit!

Can someone tell me what the stock water pump, alternator and crank pulley diameters are for a small block ford v8? Cheers Chris

Can anyone tell what the part numbers are for the following: Mk2 Granada front hub nuts Mk2 Granada front hub washers Mk3 Granada rear hub nuts Mk3 Granada rear hub washers Cheers Chris

Does anyone know where i can get a decent car cover from preferably fitted?

Has anyone got any recomendations on what paint to use when painting an engine? Everything is in bits at the moment so it's a good time for a clean up, but i don't want to pick the wrong paint and have everything look nice right up until the point it gets hot and then find all the paint starts...

I'm about to start rebuilding a 289. Can someone tell me what bolts i need to mount the block on the engine stand? Also if anyone else has got a clark engine stand it would be useful to know the length of the bolts to use?

Does anyone know the origin/maker of the brake master cylinder used on the GTD?