Search results

Thanks, I'll research it

Does anyone know where to find gasket material better than the original to replace headlight and side window gaskets ? Thanks

I have an SPF GT 40 that is about 6 years old #2178 and the air conditioning has always been marginal on hot days. Does anyone know of improvements to make the system colder ?

thanks

Has anyone found a way to cover light scratches on the Superformance GT 40 dash, without re painting the entire dash ?

I will be at the fernley track event on 9/21 Lambo club rented the track. I am taking back my helmet to Summit tomorrow to see if I can get one a little smaller.I really don't want to race with towels or sitting on the floor.

Does anyone have a suggestion for a low profile, open face helmet. I am 6" and a gfr 3023 doesn't work. Looking for a Snell 2010 that is low profile. My SPR GT 40 has a Gurney bubble. Thanks

Good comments, thank you

Did you ever produce a door lock kit for the SPF GT 40 ? If so, what are the details? Thanks, Larry

One of my e brake cables broke on my SPF GT 40 and the design is poor. The cable flexes at the shifter end so that it bends back and forth about one inch from the cable end and eventually breaks . Is there a better replacement design out there, or has anyone modified the factory e cable?

Thanks for all the help. After a closer look, we found that one of the shifter cables had been routed close to the exhaust manifold and had melted. Changed the cable and everything is fine

Thanks for the replies I think it is cable adjustment, but not sure how to go about it?

My RBT is difficult to get into reverse, even after going through the gears first. Any suggestions

It was determined that the detent pin was sheared and had to be replaced. This was repaired by RBT

Thanks for all the comments, I'll have more information once I actually see what I am dealing with, in terms of actual parts

That is correct' I have since found that Lloyd @ RBT makes a fork and shaft, and Dennis Orthloff makes a bracket and slave, to make the throw out bearing external; thus making a bearing change fast and easy.

I used a poor choice of words , I should have said "external" not remote throw out bearing

Does anyone know of a remote throwout bearing kit for a Roush 8 stack engine?

Has anyone converted a RBT transaxle to electronic shifting ; if so ,are you satisfied?

I guess the next question should be " are happy or not with it and why"