Search results

Gents, I am about to go from a single 4 barrel to 48 IDFs. I would like to see any pictures of your set-ups and more specifically any bell crank arrangements. My current cable runs straight down the passenger side of the current set up. I am hoping I do not have to change my cable, so the...

Unfortunately, this is not the start of a joke thread! While driving around the other day, I developed a pretty nasty mechanical knocking that started low and progressed much louder over just a couple of miles. Engine sputters and lurches, but I have not lost fluids or noticeably blown anything...

Hello Gents, What lights were typically used for the lighting of the roundels? Are these just license plate lights, or is there another route? Thanks Robert

I have a 15lb cap for a 302 SBF in my GTD, but someone suggested that may be too high. I don't recall it ever popping to the expansion. I keep chasing a leak around the water pump. Recently replaced the timing chain cover to a version better suited for shorty water pumps. I run my tester up...

Been chasing a slight water leak for a while now. Found out that stock timing chain covers don't work well with shorty water pumps due to the absence of the two internal bolts. Go that rectified by going with the Jegs timing chain cover, but I think the rubber gasket between the pump and the...

Gents, My GTD w/ 302 and UN1-13 is mounted with a nose down attitude, and I am trying to find out the history as to why. I am not saying this is wrong or bad, just want to know the reason. I remember seeing a thread about it having to do with the UN1, but I can't seem to find that again...

Does anyone make a spacer for the steering wheel or have a design? I have a GTD. I am on the short end of our species and find myself reaching just far enough that it makes it a little uncomfortable. I do not want to hard mount the seats. Any help is appreciated. Robert

Looking for what folks have used for covering radiator, brake cooling, and rear deck openings. I would like to see how it was mounted as well. Thanks in advance. Robert

Does anyone have a basic center tunnel concept/design for a GTD? Pictures of some of the ones that are out there on your cars would also be very helpful. I need one that can house an MR2 shifter and the emergency brake lever. Any advice on making one would be also very much appreciated...

Hello Fellas! I am looking for a center shift cable set up for a GTD using a UN1-013 gearbox. Gearbox is set up for either left or right side. Through the research on the forum, I see there are a number of solutions. So, I am open to all types and don't necessarily have a preference in...

To all, I am hoping to make 2014 the year to remember by purchasing and starting the assembly of my GT40. What I would like to ask you all for is a general sequential build plan. What did you start with first and why? What did you learn the hard way that should have been done first? Any and...

Is there anyone out there familiar with this company? A friend sent me the link. I had never heard of them, and a search on this forum did not get me anything. Home - Active Power Cars : Active Power Cars Thanks in advance. Robert

Does anyone know what serial number that GTD last produced themselves before the rights were sold off and they were produced someplace else. Also, can anyone address concerns about the later chassis being off due to incorrect jigs? Thanks in advance! Robert

Happy Holidays! Above the menu bar on this site are scrolling pictures of various types. Some appear to be assembly drawings. Can anyone tell me where these are coming from? Is it a book that I can buy or are they someone's private collection? I would love to have a set if possible. Thanks...

Hello Gents! Thank you in advance for reading my post. I live here in Texas, but before folks start holding that against me, please know that I am a genuine GT40 lover of the highest order. It is my dream to build and own one someday, so now the task of researching what I am getting myself into...