Search results

Hi all, I'm in the process of planning out my dash switch arrangement for my RCR40. Specifically what type of switch to use to move between the two fuel pumps. I was at first considering a separate switch for each but then started thinking of using either an on/off/on or an off/on/on single...

Is this an easy swap or a potential nightmare? According to the Porsche online parts catalog both the long and short versions share the same part numbers for the gasket, shaft oil seal and bushing. That would "seem" to indicate they can just be easily swapped (and then the shifter shaft...

After the frustratingly horrible experience I had with Craft Performance Engines (now out of business) - and following advice on this forum, I ordered the engine for my RCR40 from Prestige Motorsports. I guess the correct phrase is I ordered another engine for my RCR40.... My experience with...

Hi all, After considering several different ideas I had seen on the forum on how to mount the RCR40 shifter (LHD), I decided to design a slightly different solution. It mounts the shifter flush with the passenger side of the spine and it sits a 1/4" higher than the top of the spine to permit...

There is a 2016 RCR40 for sale today on Bring A Trailer. I noticed these pictures of what appears to be a textured vinyl/leather covered dash (along with stitching on the edges). Car is being sold in Texas. Does anyone know who does that covering of the dash? Or perhaps the builder of the car...

Hi all, I'm at the point of assembly where I'm beginning to drill out the openings in my dash and I started with the holes for the AC vents. However after cutting them out and placing the dash back on the car it looks to me that my dash is sitting too high. The top of the hole sits about 1"...

Hi all, I've reached the point in my RCR40 build where it's time to install the handbrake system. I have read some posts here indicating some disappointment with the system, that it isn't strong enough to pass a safety check, etc. I've already drilled the two holes to snake the cables into...

Hi all, Getting ready to install this assembly in my RCR40 and have some questions. Has anyone installed it on their build? Thanks! Chet

Hello everyone. Today I put down a deposit with Fran at Race Car Replicas on a MK1 GT40! As much as possible this will be a father-son build with my son Adam. I've been lurking on this forum for number of years while trying to make a decision so it only took me 5 short years to decide to...

Considering buying a RCR GT-40. Would anyone have experience getting one titled and registered in Florida? Any issues? Thanks! Chet

Thinking seriously of ordering a GT40 from RCR (spoke to Fran and very encouraged). However I'd like if at all possible to see one in person and talk with the owner about their build experiences. I live in Miami - are there any RCR GT40's near me? I'm willing to drive a few hours if needed...